JR XP810-3 User Manual

www.modelflight.com.au – World’s best source of JR products
4 . 5 T ravel Ad
j
ust
(
Function Mode
)
The purpose of T ravel Adjust, also known as endpoint
adjustment or adjustable travel volume, is to offer you precise
ser vo control deflection in either direction of ser vo operation.
The travel adjust range is from 0-1 5 0% (0 degrees to 6 0
degrees) from neutral and it can be adjusted for each direction
individually
. The factor y default (data reset) value is 1 00% for
each direction of servo travel.
In the Function Mode, use the UP or DN key to select the T ravel
A
djust function and access by pressing the UP and DN keys
simultaneously .
Channel being programmed
THRO Throttle
AILE Aileron
ELEV Elevator
RUDD Rudder
GEAR Retract landing gear
FLAP Flap (Aux1)
SPOI Spoiler (Aux2)
AUX3 Extra channel (Aux3)
Press the UP and DN keys
simultaneously to enter/exit
the Function Mode
Press the DN and Select key
s
simultaneously to access th
e
Function Mode List Dis
p
la
y
To Elevator/Flap
Mixin
g
function
UP
DN SELECT CH CH CLEAR
Reset travel
To Sub- Trim
function
Press to display
channels 1-4 and
5-8
(
2 screens
)
Channel
Selection
Press to increase or
decrease travel value;
move stick or switch to
manipualte arrow to the
position to be adjusted
(
hi
g
h/low, left/ri
g
ht
)
value to factory
p
reset
(
100%
)
4 . 6 Elevator to Fla
p
Mixin
g
(
Function Mode
)
The upper-most position of the flap mixing switch activates the
Elevator to Flap Mixing Circuitr y . When this system is active and
a value of flaps is input, the flaps will be deflected each time the
elevator stick is used. The actual flap movement is independently
adjustable for both up and down elevator . The most frequently
used application is up elevator/down flaps and down
elevator/up flaps. When used in this manner , the aircraft pitches
much more quickly than nor mal. When you want to reverse the
mixing directions, press the - key and change the mixing value
from + to - (or - to +).
In the Function Mode, use the UP or DN key to select the
Elevator to Flap Mixing function and access by pressing the UP
and DN keys simultaneously
.
Note: The flap mixing switch must be in the upper postion to
adjust values.
Elevator operating direction
(
D=down, U=u
p)
SW OFF appears when th
e
flap mixing switch is in th
e
middle or lower
p
osition
To Aileron/Rudde
r
UP
DN SELECT CH CH CLEAR
Reset a
pp
licable
Mixin
g
function
To Travel Adjust
function
Increase/decrease
applicable mixing
value; move the stick or
switch to manipulate
the arrow to the
position to be adjusted
(
u
p
/down
)
mixing value to
factor
y
p
reset
(
0
)
A
CRO 39

JR XP810-3 Specifications

General

Brand	JR
Model	XP810-3
Category	Remote Control
Language	English