JR XP810-3 User Manual

www.modelflight.com.au – World’s best source of JR products
4
.
1
2 Dual Fla
p
T
rim
(
Function Mode
)
, cont.
Press the UP and DN keys
simultaneously to enter/exit
the Function Mode
Press the DN and Select key
s
simultaneously to access th
e
Function Mode List Dis
p
la
y
To Trim Offset
UP
DN SELECT CH CH CLEAR
Press the Clea
r
Memor
y
function
To Butterfly
Mixin
g
function
Press either CH ke
y
to select the desire
d
trim POT
⌫ POT 5
↓
POT 6
↓
POT 7
Press the + or -
key to inhibit or
acitvate Trim
POT
key to activat
e
selected Tri
m
POT
Note: Only POT 5 will appear on the LCD unless the Dual Flap
Mixing Function is activated in the Wing Mixing Function. Refer
to the Wing Mixing Function for more information on how to
activate the Dual Flap Mixing Function.
Note: In order for POT 6 to appear on the LCD, the Switch an
d
T rim (SW+T) Selection must be activated in addition to the Dua
l
Flap Mixing Function. Refer to the Flap Channel Input Selectio
n
and Wing Mixing Sections respectively for more information.
4
.
1
3 T rim O
f
fset Memor
y
(
Function Mode
)
The T rim Of fset Memory Function allows you to test fly your
aircraft and correct for any built-in trim requirements. After you
adjust the aileron, elevator and/or rudder trim levers during test
flights, the trim levers are no longer in their center , or neutral,
positions. The use of trim offset allows you to return them to their
central or neutral positions without readjusting the linkages.
This function is ver y impor tant when switching from model to
model. It allows your trims to remain in their neutral positions.
With the use of this function, you can easily switch among the
10 model memories without readjusting for each airplane’ s trim
positions.
In the Function Mode, select T rim Of fset Memor y using the UP or
DN key and access by pressing the UP and DN keys
simultaneously .
Press the UP and DN keys
simultaneously to enter/exit
the Function Mode
Press the DN and Select key
s
simultaneously to access th
e
Function Mode List Dis
p
la
y
Press either the + or - keys to
memorize the positions, then center
trims and
p
ress Clear to store
To Flap Knob
Ad
j
ustment function
UP
DN SELECT CH CH CLEAR
Press Select, then Clear to reset all trim values to 0
To Differential Aileron Mixing
(
if activated
)
or Sna
p
Roll function
GLID 123

JR XP810-3 Specifications

General

Brand	JR
Model	XP810-3
Category	Remote Control
Language	English