To Next Page

To Previous Page

www.modelflight.com.au – World’s best source of JR products

Pro

rammable Mixin

(

1-6

)

, cont.

ssi

nin

Channels

ssi

nin

Mixin

alues

Using the SEL key

, move the cursor to the left of the master

channel. Press the left or right CH keys to position the cursor

below the master or slave channel. Press the + or - keys to select

the desired channels.

Operating with a Switch

Pressing the SEL key

, position the cursor to the side of SW

: and

using the + or - keys select the desired switch for the par

ticular

program mix being used. Refer to figure 4

3B.

Position the cursor to the left of “Point” and press the left or right

CH keys to reverse the position point. Increase or decrease the

mixing value using the + or - keys or the CLR key

. When you

wish to reverse the mixing direction, press the - key to increase

the minus value to the desired position. T

o activate point 1 or 3

with “INH” displayed, press the + or - key at that position to

display mixing value. Press the CLR key if you want to inhibit

mixing. Mixing value “0” can be set at points L, 2, and H by

pressing the CLR key

Master channel

Slave channel

Channel indicator

SPOI:

Spoiler

AILE:

Aileron

ELEV:

Elevator

RUDD:

Rudder

POT 5:

Right Aileron

POT 6:

Flap

AUX2:

Right Flap

AUX3:

Extra Channel (AUX3)

Present stick

osition

Point to be adjusted

Mixing value (maximum

100)

Mixing switch

Mixing value at

present stick

osition

ess the UP and DN keys

simultaneously to enter/exit

the Function Mode

Press the DN and Select key

simultaneously to access th

Function Mode List Dis

To Pro

rammable

SELECT CH CH CLEAR

Mixin

(

2-6

)

To Trim Offset

function

Press to move

the cursor at

left of screen

Press to select

channels to be

mixed, and to

move cursor on

graph to points to

be ad

usted

Press either the +

or - key to activate

the mixing

function, to

increase/decrease

values, and to

change the EXP

function from OFF

to ON

Press to reset value at

cursor to factory preset

position/value, or to

inhibit mixin

Note about Mixings 1 and 3:

When the slave channel is aileron, its mixing operation is

fected with preset dif

ferential.

When the slave channel is flap, its mixing operation is

fected to preset flap to aileron mixing (2 steps mixing).

Note about Mixing 2 and 4:

When the master channel is spoiler, its operation is included in

spoiler trim operations.

Note about Mixings 5 and 6:

When the master channel is aileron, elevator or rudder, the

trims are functional for the Master and Slave channels.

Mixes 5 and 6 incorporate include mixing.

GLID

126

Brand	JR
Model	XP810-3
Category	Remote Control
Language	English

JR XP810-3 User Manual

Table of Contents

Questions and Answers:

JR XP810-3 Specifications

Related product manuals