Figure 26: Connecting the SRX110 Services Gateway to the Power Supply
NOTE: The device must be connected to earth ground during normal
operation. The protective earthing terminal on the rear of the chassis is
provided to connect the device to ground.
CAUTION: We recommend using a surge protector for the power connection.
NOTE: Use the cable tie holder to secure the power cord on the power supply
point.
NOTE: We strongly recommend that you use only the 3-prong power cord
supplied with your services gateway. If you are using a 2-prong power cord,
then ensure that your device is adequately grounded using the grounding
point available on the back panel of the chassis.
Related
Documentation
Required Tools and Parts for Installing and Maintaining the SRX110 Services Gateway
on page 48
•
• Grounding the SRX110 Services Gateway on page 72
• Connecting and Organizing the SRX110 Services Gateway Interface Cables on page 75
• SRX110 Services Gateway General Safety Guidelines and Warnings on page 131
Powering On the SRX110 Services Gateway
To power on the services gateway:
1. Ensure that you have connected the power supply to the device.
Copyright © 2015, Juniper Networks, Inc.80
SRX110 Services Gateway Hardware Guide for H2 Model Numbers
To Next Page
Loading...
Need help?
General
