EasyManuals Logo
Home>Juniper>Gateway>SRX110 H2

Juniper SRX110 H2 User Manual

Juniper SRX110 H2
188 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #104 background imageLoading...
Page #104 background image
NOTE: The SRX Series devices that ship with Junos OS Release 10.0 or later
are formatted with dual-root partitions from the factory. SRX Series devices
that are running Junos OS Release 9.6 or earlier can be formatted with
dual-root partitions when they are upgraded to Junos OS Release 10.0 or
later.
For more information on dual-root partitioning, see the following topics:
•
Initial Configuration for Security Devices
•
Monitoring and Troubleshooting for Security Devices
You configure the services gateway by issuing Junos OS command-line interface (CLI)
commands.
Gather the following information before configuring the device:
•
Device name to be used on the network
•
Domain name the device will use
•
IP address and prefix length information for the Ethernet interface
•
IP address of a default router
•
IP address of a DNS server
•
Password for the root user
Understanding Built-In Ethernet Ports
Note the following points about the services gateway management ports:
•
The services gateway uses fe-0/0/1 to fe-0/0/7 as management ports to perform
initial device setup. Before initial configuration, when the factory-default configuration
is active, the device attempts to perform autoinstallation by obtaining a device
configuration through all of its connected interfaces.
•
The services gateway acts as a DHCP client out of the built-in Ethernet ports. If the
services gateway does not find a DHCP server within a few seconds, the device acts
as a DHCP server and assigns an IP address as 192.168.1.1/24. With the device
temporarily acting as a DHCP server, you can manually configure it with the J-Web
interface.
•
Any DHCP client host, for example, a PC or laptop computer, directly connected to any
of fe-0/0/1 to fe-0/0/7 ports receives an address on the 192.168.1.1/24 network.
•
Any DHCP client host, for example, a PC or laptop computer, directly connected to any
of fe-0/0/1 to fe-0/0/7 ports receives an address on the 192.168.1.1/24 network.
Copyright © 2015, Juniper Networks, Inc.84
SRX110 Services Gateway Hardware Guide for H2 Model Numbers

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Juniper SRX110 H2 and is the answer not in the manual?

Juniper SRX110 H2 Specifications

General IconGeneral
BrandJuniper
ModelSRX110 H2
CategoryGateway
LanguageEnglish

Related product manuals