Juniper SRX110 H2 User Manual

Table 32: SRX110 Services Gateway Preinstallation Checklist for
Desk-Mount Installation (continued)
Additional InformationTask
“Unpacking the SRX110 Services
Gateway” on page 51
Remove the services gateway chassis from the
shipping carton.
Verify that you have the following parts available in
your desk-mounting kit to mount the SRX110 Services
Gateway vertically:
•
Vertical stand
•
Screws
NOTE: If you are mounting the services gatewayhorizontally on a desk, ensure
that the rubber feet are attached to the chassis.
NOTE: The vertical desk-mounting kit is not shipped with the device and
must be ordered separately.
Related
Documentation
Unpacking the SRX110 Services Gateway on page 51•
• Clearance Requirements for Airflow and Hardware Maintenance of the SRX110 Services
Gateway on page 34
• Preparing the SRX110 Services Gateway for Rack-Mount Installation on page 55
• Preparing the SRX110 Services Gateway for Wall-Mount Installation on page 57
Preparing the SRX110 Services Gateway for Wall-Mount Installation
You can mount an SRX110 Services Gateway on a wall. The four rubber feet attached to
the chassis provide stability.
Table 33 on page 57 provides the list of tasks you need to perform before installing the
device.
Table 33: SRX110 Services Gateway Preinstallation Checklist for
Wall-Mount Installation
Additional InformationTask
Site Preparation Checklist for the SRX110
Services Gateway
Verify that the site meets the requirements.
“Unpacking the SRX110 Services
Gateway” on page 51
Remove the services gateway chassis from the shipping
carton.
57Copyright © 2015, Juniper Networks, Inc.
Chapter 9: Installing the Mounting Hardware

Juniper SRX110 H2 Specifications

General

Brand	Juniper
Model	SRX110 H2
Category	Gateway
Language	English