Juniper SRX110 H2 User Manual

Table 31: SRX110 Services Gateway Preinstallation Checklist for
Rack-Mount Installation (continued)
Additional InformationTask
Verify that you have the following parts available
in your rack-mounting kit for the SRX110 Services
Gateway:
•
Rack-mounting brackets
•
Mounting screws
•
Power supply adapter tray with screws
•
Adapter stopper bracket
“Adjusting the Power Supply Adapter Tray
for the SRX110 Services Gateway for
Rack-Mount Installation” on page 62
Adjust the power supply adapter tray.
NOTE: The rack-mounting kit is not shipped with the device and must be
ordered separately.
Related
Documentation
Unpacking the SRX110 Services Gateway on page 51•
• Clearance Requirements for Airflow and Hardware Maintenance of the SRX110 Services
Gateway on page 34
• Preparing the SRX110 Services Gateway for Desk-Mount Installation on page 56
• Preparing the SRX110 Services Gateway for Wall-Mount Installation on page 57
Preparing the SRX110 Services Gateway for Desk-Mount Installation
You can mount the services gateway on a desk or other level surface horizontally or
vertically. The four rubber feet attached to the chassis provide stability.
Table 32 on page 56 provides the list of tasks you need to perform before installing the
device.
Table 32: SRX110 Services Gateway Preinstallation Checklist for
Desk-Mount Installation
Additional InformationTask
Site Preparation Checklist for the SRX110
Services Gateway
Verify that the site meets the requirements.
“Clearance Requirements for Airflow and
Hardware Maintenance of the SRX110
Services Gateway” on page 34
Place the desk in its permanent location, allowing
adequate clearance for airflow and maintenance, and
secure it to the building structure.
Copyright © 2015, Juniper Networks, Inc.56
SRX110 Services Gateway Hardware Guide for H2 Model Numbers

Juniper SRX110 H2 Specifications

General

Brand	Juniper
Model	SRX110 H2
Category	Gateway
Language	English