Juniper SRX110 H2 User Manual

Table 45: Component LEDs on the Services Gateway
Possible Causes and
Corrective ActionsMeaningStateLED
Normal condition. No action
is required.
Indicates that the device is
functioning normally.
GreenStatus LED
Normal condition. No action
is required.
•
The device is starting up.
•
The Reset Config button
is pressed.
Amber
Contact the Juniper
Networks Technical
Assistance Center (JTAC).
See “Juniper Networks
Technical Assistance
Center” on page 117.
Indicates an error in the
device.
Red
Normal condition. No action
is required.
Indicates that the device is
functioning normally.
Green
Alarm LED
A critical alarm indicates a
critical situation on the
gateway that requires
immediate action.
See “Monitoring the SRX110
Services Gateway Using
Chassis Alarm Conditions”
on page 112.
The device indicates a critical
alarm.
Red
A major alarm requires
monitoring or maintenance.
If left unchecked, it might
cause an interruption in
service or degradation in
performance.
See “Monitoring the SRX110
Services Gateway Using
Chassis Alarm Conditions”
on page 112.
The device indicates a major
alarm.
Amber
Normal condition. No action
is required.
The device is starting up.
NOTE: When the system is
up and running, if the Alarm
LED is off, it indicates that no
alarms are present on the
device.
Off
111Copyright © 2015, Juniper Networks, Inc.
Chapter 16: Troubleshooting Components

Juniper SRX110 H2 Specifications

General

Brand	Juniper
Model	SRX110 H2
Category	Gateway
Language	English