CHAPTER 12
Connecting the SRX110 Services Gateway
to External Devices
•
Connecting and Organizing the SRX110 Services Gateway Interface Cables on page 75
•
Connecting the Modem at the SRX110 Services Gateway End on page 76
•
Connecting the Modem to the Console Port on the SRX110 Services Gateway on page 77
•
Connecting to the CLI at the User End for the SRX110 Services Gateway on page 77
Connecting and Organizing the SRX110 Services Gateway Interface Cables
You can connect the interfaces installed in the services gateway to various network
media. Each type of interface on the services gateway uses a particular medium to
transmit data. You must configure each network interface before it can operate on the
device.
To connect and organize an interface cable for the device:
1. Have ready a length of the type of cable used by the interface.
2. Insert the cable connector into the cable connector port on the interface faceplate.
3. Arrange network cables as follows to prevent them from dislodging or developing
stress points:
•
Secure cables so that they are not supporting their own weight as they hang to the
floor.
•
Place excess cable out of the way in neatly coiled loops.
•
Use fasteners to maintain the shape of cable loops.
Related
Documentation
Connecting the SRX110 Services Gateway to the Power Supply on page 79•
• Grounding the SRX110 Services Gateway on page 72
• Interface Cable and Wire Specifications for the SRX110 Services Gateway on page 41
• General Site Guidelines for Installing the SRX110 Services Gateway on page 30
75Copyright © 2015, Juniper Networks, Inc.
To Next Page
Loading...
Need help?
General
