Section 14: SCPI command reference Model 6517B Electrometer Reference Manual
14-24 6517B-901-01 Rev. C / August 2015
Command Description Default parameter SCPI
:HLControl <b>
Enable or disable the A/D hardware limit
:HLControl?
Query state of hardware limit OFF
:HSControl <b>
Enable or disable humidity readings
:HSControl?
Query state of humidity readings
:LOCal
Take 6517B out of remote (RS-232 only)
:REMote
Put 6517B in remote (RS-232 only) OFF
:LLOCkout <b>
Enable or disable local lockout (RS-232
only)
:SYSTem
:MACRo
:TRIGger
Paths to configure Basic triggering
[:EXECute]
Select basic triggering
:MODE <name>
Specify trigger mode (CONTinuous or
ONEShot)
CONTinuous
:SOURce <name>
Specify source (IMMediate,
MANual, BUS, EXTernal or TIMer)
IMMediate
:TIMer <n>
Specify timer interval; 0.001 to
99999.999 (sec)
0.1
:INTerlock?
Query if interlock cable connected to
fixture
(1=yes)
Note: Clearing the error queue: Power-up and *CLS: Clears the error queue.
*RST, :SYSTem:PRESet, and :STATus:PRESet: No effect.
To Next Page
Loading...
Need help?
General
