To Next Page

To Previous Page

Section 14: SCPI command reference Model 6517B Electrometer Reference Manual

14-92 6517B-901-01 Rev. C / August 2015

:LIMit:STATe

This command is used to control the voltage limit.

Usage

:SOURce:VOLTage:LIMit:STATe

:STATe?

 0 or OFF: sable voltage limit

 1 or ON: Enable voltage limit

Details

This command is used to enable or disable voltage limit. When enabled, the programmed voltage

limit is in effect. When disabled, voltage limit is determined by the selected range.

Attempts to enable voltage limit when the present V-source level (amplitude) exceeds the limit value

generates a Settings Conflict error.

Also see

None

:MCONnect

This command is used to control the LO connection.

Usage

:SOURce:VOLTage:MCONnect

:MCONnect?

 ON or 1: Enable LO connection

 OFF or 0: Disable LO connection

Details

This command is used to control the internal V-source LO to Ammeter LO connection. When enabled,

V-source LO is connected to Ammeter LO. This connection simplifies the connection requirements for

ohms measurements and source voltage measure current measurements. When disabled, this

connection is broken.

Also see

None

Keithley 6517B Reference Manual

Other manuals for Keithley 6517B