To Next Page

To Previous Page

Section 14: SCPI command reference Model 6517B Electrometer Reference Manual

14-136 6517B-901-01 Rev. C / August 2015

:TIMer <n>

This command sets the timer interval.

Usage

:SYSTem:MACRo:TRIGger:TIMer <n>

<n>

 0.001 to 99999.999: Specify timer interval in seconds

 DEFault: 0.1 seconds

 MINimum: 0.001 seconds

 MAXimum: 99999.999 seconds

Details

This command is used to specify the time interval for the timer. The :SOURce TIMer command is

used to select the timer as the control source.

Also see

None

:INTerlock?

This command determines if the safety interlock cable is connected to the Model 6517B.

Usage

SYSTem:INTerlock?

Details

This query command is used to determine if the safety interlock cable is connected to the Model

6517B. The response message is interpreted as follows:

1 = Interlock cable connected to the 6517B and fixture, or not connected to 6517B at all.

0 = Interlock cable connected to 6517B but not connected to fixture, or interlock cable connected to

6517B but fixture lid is open.

If the interlock cable is not connected, the Model 6517B cannot determine the state of the test fixture

lid (open or closed) or read the test fixture switch settings. A potential safety hazard is present when

the fixture lid is open.

Also see

None

:TRACe subsystem

The commands in this subsystem are used to configure and control data storage into the buffer. The

commands are summarized in :TRACe command summary (on page 14-25). See Buffer (data store)

for more information about the buffer.

Keithley 6517B Reference Manual

Other manuals for Keithley 6517B