MACHINE OPERATIONS AND CONTROLS
5.
Set the lock lever (2) to LOCK position (L).
6.
Check the engine coolant temperature and engine oil pres-
sure with the machine monitor.
• If the engine coolant temperature gauge is in the red
range, cool down the coolant until the gauge enters
the green range, and stop the engine. Then, inspect
and take necessary remedy according to “TROUBLES
AND ACTIONS (3-234)”.
• If the engine oil pressure caution lamp is lit, stop the
engine immediately. Then, inspect and take necessary
remedy according to “TROUBLES AND ACTIONS
(3-234)”.
7.
Stop the engine.
For the stopping procedure of the engine, see “METHOD FOR STOPPING ENGINE (3-167)”.
METHOD FOR CHECKING AFTER FINISHING WORK
Perform it after stopping the engine.
1.
Walk around the machine and check the work equipment, machine exterior, and undercarriage, also check
for any leakage of oil or coolant. If any problems are found, repair them.
2.
Fill the fuel tank.
3.
Check the engine compartment for paper and debris. Clean out any paper and debris to avoid a fire hazard.
4.
Remove any mud affixed to the undercarriage.
To Next Page
Loading...
