HANDLE RADIO
• To ensure safety, always keep the sound to a level where it is possible to hear outside sounds during opera-
tion.
• If water gets into the speaker case or radio, it may lead to an unexpected failure, so be careful not to get
water on the equipment.
• Do not wipe the display or buttons with solvent such as benzene or thinner. Wipe with a dry soft cloth.
• When the battery disconnect switch is turned to OFF position or the power for the machine is off at the re-
placement of the battery, the clock may be initialized. In such a case, set it again.
For handling of the battery disconnect switch, see “BATTERY DISCONNECT SWITCH (3-110)”.
EXPLANATION OF RADIO EQUIPMENT
(1) Power button
(2) Band/AUX selector button
(3) Volume control button
(4) Tuning/time adjustment button
POWER BUTTON
(5) Preset button
(6) Display selector button
(7) Sound control button
(8) Display
Press the power button to supply the power to the radio and the frequency is shown on display. As long as AUX
is selected, display indicates AUX on it. Press the button again to turn the power off.
BAND/AUX SELECTOR BUTTON
Press band/AUX selector button to select the desired band or AUX.
Each time the button is pressed, the band changes FM → AM → AUX → FM...
VOLUME CONTROL BUTTON
Use the volume control button to control the volume.
Press the △ button, and the volume increases. Press the ▽ button, and the volume decreases. The range for
the volume is 0 to 32.
Hold down this button, and you can change the volume continuously.
TUNING/TIME ADJUSTMENT BUTTON
Use the tuning/time adjustment button to select frequency and step for sound adjustment and to adjust time.
To Next Page
Loading...
Need help?
General
