8
Specifying settings using PageScope Web Connection
8-64 200/250/350
Specifying settings using PageScope Web Connection Chapter 8
8.16 LDAP (Administrator mode)
The settings used by the LDAP (Lightweight Directory Access Protocol) serv-
er in a network can be specified.
Settings can be specified for the following.
Specifying the LDAP settings
1 In the Administrator mode, click the Network tab.
– For the procedure to log on to Administrator mode, refer to “Log-
ging on to Administrator mode” on page 8-8.
2 Click [Common Setting], then [LDAP].
3 Select whether to enable or disable LDAP searches, and then click [Ap-
ply].
Item Description
LDAP Select whether to enable or disable address searches where the LDAP server
is used. If “Enable” is selected, the LDAP server can be specified.
Search Default
Setting
Select which of the registered LDAP servers is to be accessed. This
parameter appears if an LDAP server has been registered.
To Next Page
Loading...
Need help?
General
