To Next Page

To Previous Page

Specifying management settings

9-36 200/250/350

Specifying management settings Chapter 9

Specifying administrator forwarding settings (mode 198)

You can specify whether a received document is forwarded to a destination

specified by the administrator.

Factory settings

Specifying settings

The shaded cells represent the factory settings. The page numbers on the

right refer to the descriptions of the corresponding functions.

(*) Bit 7 of mode 198 is enabled only when “1 (transmit)” is specified.

Bit 7 6 5 4 3 2 1 0

Setting 1 1 0 1 0 0 0 0 (HEX: D0)

Bit Description Setting Description Page Ref-

erence

7 Specifies whether a received

document is forwarded to a

destination specified by the

administrator.

0Not forwarded page9-21

1Forwarded

6 Specifies whether to enable

TX Forwarding when scan-

ning.(*)

0 Not forwarded ---------

1Forwarded

5, 4 Specifies the print condi-

tions of transmission reports

for TX Forwarding.(*)

00 Not output ---------

01 Undeliverable

10 Always prints

11 *Do not specify these set-

tings.

3, 2, 1, 0 -----------------------------

0000 *Do not change these bits

when specifying settings for

this function.

---------

Konica Minolta Printer/Fax/Scanner/Copier 250 User Manual

Questions and Answers: