8
Specifying settings using PageScope Web Connection
8-78 200/250/350
Specifying settings using PageScope Web Connection Chapter 8
8.19 FTP Configuration (Administrator mode)
Detailed FTP proxy server and FTP server settings can be specified.
Settings can be specified for the following.
* If the setting of a parameter marked with [*] is changed, turn this machine off, then on again.
Specifying the FTP settings
1 In the Administrator mode, click the Network tab.
– For the procedure to log on to Administrator mode, refer to “Log-
ging on to Administrator mode” on page 8-8.
2 Click [FTP Configuration].
3 Specify a setting for each parameter, and then click [Apply].
Item Description
Proxy IP
Address
Type in the IP address or host name (up to 64 characters) for the proxy server.
For details on the settings to be specified, contact the network administrator.
Port Number Type in the number (between 1 and 65535) of the port where the FTP server
is connected.
FTP Server [*] Select whether or not the FTP server is used.
FTP
Connection
Timeout
Select the time until the connection with the FTP server is timed out. Select
from 30, 60, 90, 120, 150, 180, 210, 240, 270 and 300 seconds.
To Next Page
Loading...
Need help?
General
