Specifying management settings
9
200/250/350 9-45
Specifying management settings Chapter 9
Including the scan transmission log in the activity report (mode 368)
Specify whether or not the transmission log is included in the activity report.
Factory settings
Specifying settings
The shaded cells represent the factory settings. The page numbers on the
right refer to the descriptions for the corresponding functions.
Bit 7 6 5 4 3 2 1 0
Setting 1 1 0 0 0 0 1 0 (HEX: C2)
Bit Description Setting Description Page
Refer-
ence
7, 6, 5, 4,
3, 2
----------
110000 *Do not change these bits
when specifying settings for
this function.
----------
1 Specifies whether or not the
log is included in the activity
report during scan transmis-
sions.
0 Not included ----------
1Included
0 ----------
0 *Do not change this bit when
specifying settings for this
function.
----------
To Next Page
Loading...
Need help?
General
