LUBRICANTS, FUEL AND COOLANT
No. Locations
Capacities
Lubricants
ROPS CAB
LX2610
LX2610SU
LX3310 LX2610 LX3310
1 Fuel
27 L
(7.1 U.S.gals.)
32 L
(8.4 U.S.gals.)
No.2-D diesel fuel
No.1-D diesel fuel if temperature is below -10 ℃
(14 ℉)
2
Coolant
(with recovery tank)
4.3 L
(4.5 U.S.qts.)
Fresh clean water with antifreeze
3 Washer liquid －
1.5 L
(1.6 U.S.qts.)
Automobile washer liquid
4
Engine crankcase
(with filter)
4.0 L
(4.2
U.S.qts.)
4.7 L
(5.0
U.S.qts.)
4.0 L
(4.2
U.S.qts.)
4.7 L
(5.0
U.S.qts.)
• Engine oil: refer to the following table
Above 25 ℃
(77 ℉)
SAE30,
SAE10W
-30 or 15W-40
-10 ℃ (14 ℉) to
25 ℃ (77 ℉)
SAE20,
SAE10W-30 or 15W-40
Below -10 ℃
(14 ℉)
SAE10W-30
5 Transmission case
15 L
(4.0 U.S.gals.)
• KUBOTA SUPER UDT-2 fluid
6 Front axle case
4.7 L
(5.0 U.S.qts.)
• KUBOTA SUPER UDT-2 or SAE 80-SAE 90
gear oil
7
Greasing No. of greasing points Capacity Type of grease
Top link 1
Until grease over-
flow.
Multipurpose grease
NLGI-2 or NLGI-1 (GC-LB)
Lifting rod (RH) 1
Speed control pedal － 1
Brake pedal 1 －
Battery terminals 2 Moderate amount
NOTE :
• The
product name of Kubota genuine UDT fluid may be different from that in the operator's manual
depending on countries or territories. Consult your local KUBOTA Dealer for further details.
Engine oil
• The oil used in the engine should have an American Petroleum Institute (API) service classification and proper
SAE engine oil according to the ambient temperatures shown in the previous table.
• Refer to the following table for the suitable API classification engine oil according to the diesel particulate filter
(DPF) type engines and the fuel.
Fuel used
Engine oil classification (API classification)
Oil class of engines except external DPF
[LX2610/LX2610SU]
Oil class of engines with external DPF
[LX3310]
Ultra low sulfur fuel
<0.0015% (15 ppm)
CF, CF-4, CG-4, CH-4 or CI-4 CJ-4
• The CJ-4 engine oil is intended for diesel particulate filter (DPF) type engines.
Fuel
• Use the ultra-low sulfur diesel fuel only (below 0.0015% or 15 ppm) for these engines.
• Cetane number of 45 minimum. Cetane number greater than 50 is preferred, especially for temperatures below
-20 ℃ (-4 ℉) or elevations above 1500 m (5000 ft).
• Diesel fuels specified to EN 590 or ASTM D975 are recommended.
MAINTENANCE LUBRICANTS, FUEL AND COOLANT
To Next Page
Loading...
Need help?
General
