Kubota LX2610 User Manual

IMPORTANT :
• The
universal joint of the PTO drive shaft is
technically limited in its moving angle. Refer to
the PTO drive shaft instructions for proper use.
6. Stationary PTO
To park the tractor and use the PTO system (for chipper
or
pump, for example), start the PTO system in the
following steps.
1. Apply the parking brake and place blocks at the
tires.
2. Make sure the shift levers are at neutral, and start
the engine.
3. Set the PTO select lever to “rear PTO” position.
[except LX2610SU]
4. Push and hold the stationary PTO switch for more
than 1 second and the switch light will turn on.
ROPS model
(1) Stationary PTO switch
CAB model
(1) Stationary PTO switch
5. Set the PTO clutch lever to “ON” position.
6. Set
the engine speed to provide recommended rear
PTO speed.
7. Get off the tractor.
ROPS model
(1) Seat
(2)
Parking brake lever
(3) PTO clutch lever
(4) PTO select lever [except
LX2610SU]
(A) “ON”
(B) “OFF”
CAB model
(1) Seat
(2)
Parking brake lever
(3) PTO clutch lever
(4) PTO select lever
(A) “ON”
(B) “OFF”
NOTE :
• If
the PTO system is engaged and you stand up
from the seat and release the parking brake, the
engine stops automatically.
PTO OPERATION PTO
LX2610,LX3310
77

Kubota LX2610 Specifications

General

Brand	Kubota
Model	LX2610
Category	Tractor
Language	English