3. Front work light
(1) Front work light
4. Rear work light (if equipped)
(1) Rear work light
WIPER
1. Front wiper and washer switch
When the button is pressed to the first step, the wiper
only is activated.
When
the button is pressed further to the second step,
washer fluid jets out.
The washing continues while the button is pressed and
wiper is activated continuously. (Washer fluid jets out to
the rear window also.)
Hold down the bottom half of the switch when the front
wiper is off, and washer fluid will keep jets out.
To wet the glass before activating the wipers, press the
bottom half of the switch. (Washer fluid jets out to the
rear window also.)
(1) Front wiper and washer switch
2. Rear wiper and washer switch
Press the upper half of the wiper switch, and the wiper
is
activated. Press the lower half of the wiper switch,
and the wiper stops at the initial position.
To jet washer fluid, push the front wiper and washer
switch. (Washer fluid jets out to the front window also.)
(1) Rear wiper switch
IMPORTANT :
• Do
not activate the wipers when the windows
are dry, they may be scratched.
Be sure to jet washer fluid first and then
activate the wipers.
3. Using the wipers in cold season
1. While
not used in cold season, keep the wiper
blades off the windshield to prevent them from
being frozen to the windshield.
2. If the windshield is covered with snow, scrape it off
the windshield before using the wipers.
3. If the wiper blades are frozen to the windshield and
fail to move, be sure to turn the main key switch to
“OFF” and remove the ice from the blades. Then
place the main key switch back to “ON”.
LIGHT CAB OPERATION
To Next Page
Loading...
Need help?
General
