EasyManuals Logo
Home>Kubota>Tractor>LX2610

Kubota LX2610 User Manual

Kubota LX2610
154 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #138 background imageLoading...
Page #138 background image
(1) Differential pressure sensor
(2)
Hose
6. Replacing air conditioner hose
(CAB model)
Consult your local KUBOTA Dealer for this service.
SERVICE AS REQUIRED
1. Bleeding fuel system
Air must be removed:
When the fuel filter or lines are removed.
When the water is drained from the water
separator. [LX3310]
When the tank is completely empty.
After the tractor has not been used for a long period
of time.
Bleeding procedure [LX2610/LX2610SU]
1. Fill the fuel tank with fuel.
2. Start the engine and run for about 30 seconds, and
then stop the engine.
Bleeding procedure [LX3310]
1. Fill the fuel tank with fuel, and open the fuel shutoff-
valve.
2. Loosen the air vent plug until the liquid level rises.
(1) Fuel shutoff-valve
(2)
Air vent plug
(A) “OPEN”
(B) “CLOSE”
3. Wait until air in the tank is removed.
Turn on the key when the increase of liquid level is
slow.
4. Set the hand throttle lever at the minimum speed
position, turn the key switch to the start position.
If the engine does not start, try it several times at
30-second intervals.
IMPORTANT :
Do not hold the key switch at the engine
start position for more than 10 seconds
continuously. If more engine cranking is
needed, try again after 30 seconds.
5. Accelerate the engine to remove the small portion
of air left in the fuel system.
6. If air still remains and the engine stops, repeat the
previous steps.
2. Draining clutch housing water
The tractor is equipped with a drain plug under the
clutch housing.
After
operating in the rain or snow, or if the tractor has
been washed, water may get into the clutch housing.
Remove the drain plug, drain the water and then
reinstall the plug.
(1) Water drain plug
3. Replacing fuses
The tractor electrical system is protected from potential
damage by fuses.
A
blown fuse indicates that there is an overload or short
somewhere in the electrical system.
If any of the fuses should blow, replace with a new one
of the same capacity.
IMPORTANT :
Before replacing a blown fuse, determine why
the fuse blew and make any necessary repairs.
Failure to follow this procedure may result in
serious damage to the tractor electrical system.
For specific information dealing with electrical
problems, read the troubleshooting section of
 PERIODIC SERVICE EVERY 4 YEARS
136
LX2610,LX3310

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kubota LX2610 and is the answer not in the manual?

Kubota LX2610 Specifications

General IconGeneral
BrandKubota
ModelLX2610
CategoryTractor
LanguageEnglish

Related product manuals