• Be
sure to stop the engine before changing the
oil filter cartridge.
• Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. Place the oil pan underneath the transmission oil
filter and remove the filter.
Do not remove the hydraulic oil filter. Otherwise, the
oil comes out.
[LX2610/LX3310]
(1) Transmission oil filter
[LX2610SU]
(1) Transmission oil filter
2. Put
a film of clean transmission oil on the rubber
seal of the new filter.
3. Quickly tighten the filter until it contacts the
mounting surface, then, with a filter wrench, tighten
it an additional 1 turn only.
4. After the new filter has been replaced, fill the
transmission oil up to the upper limit on the dipstick.
(1) Oil inlet
(2)
Dipstick
(A) Oil level is acceptable within
this range
5. After
running the engine for a few minutes, stop the
engine and check the oil level again, add oil to the
prescribed level.
6. Make sure that the transmission fluid does not leak
past the seal on the filter.
IMPORTANT :
• To prevent serious damage to the hydraulic
system, use only a KUBOTA genuine filter.
• Do not operate the tractor immediately after
changing the transmission fluid.
Run the engine at medium speed for a few
minutes to prevent damage to the
transmission.
4. Checking power steering line
1. Check
to see that all lines and hose clamps are
tight and not damaged.
PERIODIC SERVICE EVERY 200 HOURS
To Next Page
Loading...
Need help?
General
