Never operate the tractor while an Easy Checker
™
indicator is on.
(1) Easy Checker
™
Engine warning [LX3310 only]
If the regeneration of the DPF has a problem, the
warning lamp in the Easy Checker
™
will come on.
(See PM warning level and required procedures on
page 46.)
Engine overheat
If the water temperature gauge reads an unusual
level and the indicator on the
Easy Checker
™
comes on, the engine may have overheated. Check
the tractor by reading the troubleshooting section of
this manual.
(See TROUBLESHOOTING on page 143.)
Engine oil pressure
If the oil pressure in the engine drops below the
prescribed level, the indicator on the
Easy
Checker
™
will come on.
If this should happen during operation, and it does
not go off when the engine is accelerated to more
than 1000 rpm, check the engine oil level.
(See Checking engine oil level on page 112.)
Water separator [LX3310 only]
If water or impurities collect in the water separator
,
the indicator on the Easy Checker
™
will light up.
If this should happen during operation, drain the
water from the water separator as soon as possible.
(See Checking water separator [LX3310] on page
112.)
Emission indicator [LX3310 only]
If this indicator lights up, take steps to lower the
water temperature.
This helps keep the emission clean.
Electrical charge
If the alternator is not charging the battery
, the
indicator on the Easy Checker
™
will come on.
If this should happen during operation, check the
electrical charging system or consult your local
KUBOT
A Dealer.
Master system warning
If the trouble is not corrected by restarting the
tractor
, consult your local KUBOTA Dealer.
NOTE :
• For checking and servicing of your tractor,
consult your local KUBOTA Dealer for
instructions.
4. Fuel gauge
When the key switch is on, the fuel gauge indicates the
fuel level.
Be
careful not to empty the fuel tank. Otherwise air may
enter the fuel system.
Should this happen, the system should be bled.
(See Bleeding fuel system on page 136.)
(1) Fuel gauge (A) “EMPTY”
(B)
“FULL”
5. Coolant temperature gauge
WARNING
T
o avoid personal injury or death:
• Do not remove the radiator cap until coolant
temperature is well below its boiling point.
Then, loosen the cap slightly to the first stop to
relieve any pressure before removing the cap
completely.
1. With the key switch at “ON”, this gauge indicates
the temperature of the coolant. [C] is for cold and
[H] is for hot.
2. If the indicator reaches the [H] position (red zone),
the engine coolant is overheated. Check the tractor
by reading the troubleshooting section of this
manual.
(See TROUBLESHOOTING on page 143.)
OPERATING THE TRACTOR CHECK DURING DRIVING
To Next Page
Loading...
Need help?
General
