• Preferably
set the cruise control lever, while
holding down the speed control pedal. This
makes the setting smoother.
• When releasing the cruise mode, be sure to
return the cruise control lever fully backward.
(1) Cruise control lever (A) “INCREASE”
(B)
“DECREASE”
(C) “NEUTRAL”
NOTE :
• When you stand up from the seat with the
speed control pedal depressed or the cruise
control lever engaged (“ON”), the engine will
stop regardless of whether the machine is
moving or not. This is because the tractor is
equipped with operator presence control (OPC)
system.
STOPPING THE TRACTOR
1. Slow down the engine.
2.
Step on the brake pedal.
3. Wait for the tractor to stop.
4. Disengage the PTO.
5. Lower the implement to the ground.
6. Shift the transmission to neutral.
7. Set the parking brake.
CHECK DURING DRIVING
IMPORTANT :
Immediately stop the engine if:
• The
engine suddenly slows down or
accelerates.
• Unusual noises are suddenly heard.
• Exhaust fumes suddenly become very dark.
1. Fuel temperature indication
Fuel temperature indication informs the operator of high
fuel temperature by showing a message on the display
.
If “FUEL.H”
appears on display, immediately stop
operation and idle the engine.
When the engine rpm decreases, the message on the
display will disappears.
(A) “FUEL.H”
2. Engine low temperature regulation
In order to prevent engine damage due to rapid
acceleration,
if starting the engine when the coolant
temperature is approximately 0 ℃ (32 ℉) or below, the
engine rpm will be kept at approximately 1800 for up to
1 minutes. The operator will be informed by “Cold” on
display, flash of engine revolution speed, and
intermittent buzzer. The regulation time varies in
response to the coolant temperature.
During regulation, perform the warm-up operation
without using the accelerator. After regulation, the
engine rpm can be gradually increased. When
regulation has been completely released, the indicator
will go off, and the buzzer will stop.
(A) “Cold”
(B)
Flash
3. Easy Checker
™
If the indicators on the Easy Checker
™
come on during
operation, immediately stop the engine and find the
cause as follows.
STOPPING THE TRACTOR OPERATING THE TRACTOR
To Next Page
Loading...
Need help?
General
