3. Add the engine oil if necessary.
(1) Oil port
(2)
Oil dipstick
(A) Proper oil level
Engine oil capacity 9.0 L
IMPORTANT :
• Use
engine oil with the correct viscosity
according to the outside temperature.
• After stopping the engine and remove the
starter key, wait 5 minutes, then check the
level of engine oil. Place the machine on
level ground.
• A small amount of fuel used for DPF-
regeneration may get mixed with the engine
oil, which can increase the level of engine oil
slightly.
• Do not try to repeat or interrupt the DPF-
regeneration process unnecessarily.
Repeating or interrupting of the DPF-
regeneration can increase the small amount
of fuel that gets mixed with the engine oil,
thereby degrading it.
• If the oil rises above the oil-level-gauge
upper limit, it means the oil has been diluted
too much, resulting in a trouble. In such
case, immediately change the oil for new
one.
2. Checking and replenishing the
hydraulic oil
WARNING
To avoid personal injury or death:
• Never open the oil port immediately after the
engine has stopped or hydraulic oil may
escape, causing scalding.
1. Stop
the machine on flat ground, lower the bucket
to the ground, and roll back the bucket.
2. Check the level of hydraulic oil in the oil-level-
gauge.
If the level of hydraulic oil is between the upper and
lower
marks, the amount of the hydraulic oil is
appropriate.
DAILY CHECK PERIODIC SERVICE
To Next Page
Loading...
Need help?
General
