2. When
the bucket is sufficiently driven into the sand,
lift the bucket while advancing the machine.
(1) Sand pile
(2)
Bucket
(A) Sufficient drive into sand
(B) Lift
3. If
the bucket is insufficiently driven into the sand,
move the bucket blade up and down while moving
forward.
(1) Sand pile
(2)
Bucket
(A) Insufficient drive into sand
(B) Up and down
1.2 Digging and loading from flat ground
1. Direct
the bucket blade slightly downward and lower
the bucket as you advance the machine.
(1) Bucket blade (A) Driving direction
The recommended digging depth per pass is as
follows.
Digging depth per pass Between 10 cm and 15 cm
2. While
adjusting the vertical movement of the
bucket, lift the bucket so that sand can be removed
by layers. Continue lifting the bucket as you
advance the machine.
(1) Bucket (A) Driving direction
(B)
Lift
2. Refilling
1. Direct
the bucket horizontally and push the piled
sand toward the ditch.
2. When the bucket reaches the ditch, dump the
bucket to discharge the sand into the ditch.
(1) Ditch
3. Leveling the ground
1. Dump
and tilt the bucket alternately to distribute the
soil from the bucket over the ground as you move
the machine backward.
2. Dump the bucket, lower the bucket, and move the
machine backward so that the blade scratches the
ground surface.
OPERATION OF THE MACHINE TYPICAL JOBS USING A WHEEL LOADER
To Next Page
Loading...
