10. T
ake up the mat, remove the bolts, and detach the
access flap.
Hydraulic oil port is under the floor.
(1) Mat
(2)
Access flap
(3) Bolts
(4) Oil port cap
Hydraulic oil volumes
Hydraulic tank 39 L
Whole oil volumes 55 L
IMPORTANT :
•
If there are deposits in the hydraulic-oil-tank,
wipe them all with a clean rag and diesel oil.
• Use great caution not to admit any foreign
particles into the hydraulic-oil-tank.
4. Replacing the air cleaner element
1. Open
the engine cover, and remove the air-cleaner
cover and both air-cleaner elements.
2. Change both air-cleaner elements and clean the
inside of the air-cleaner cover.
3. Reinstall the air-cleaner elements and the air-
cleaner cover being careful to install the cover so
that its “TOP” mark (arrow) faces upwards.
(1) Outer element
(2)
Inner element
(3) Cramp
(4) Air cleaner cover
5. Adjusting the engine valve
clearance
Consult your local KUBOTA dealer for adjusting the
engine valve clearance.
SERVICE EVERY 1500 HOURS
Perform all 50, 100, and 500 hour servicing at the same
time.
1. Checking the injector
Consult your local KUBOTA dealer for checking the
injector
.
2. Replacing the oil separator
element
WARNING
T
o avoid personal injury or death:
• Be sure to stop the engine before replacing the
oil-separator element.
1. Remove
the cover and remove the oil-separator
element.
2. Wipe off the oil and the carbon in the case with a
clean rag.
3. Fit a new oil-separator element and O-ring.
PERIODIC SERVICE SERVICE EVERY 1000 HOURS
To Next Page
Loading...
Need help?
General
