COMPLETION OF OPERATION AND STORING
STORING THE MACHINE
WARNING
T
o avoid personal injury or death:
• Before storing, perform the following
procedure.
1. Stop the engine.
2. Lower the bucket and attachment to the
ground.
3. Release the hydraulic pressure in the
hydraulic system by operating the control
levers.
4. Remove the starter key.
Measures before completion of operation
1. W
ash and clean each part of the machine, and
store the machine indoors.
Never leave the machine outdoor.
If you must store the machine outdoors, choose a
flat place, lay planks, park the machine, and cover it
completely.
2. Add oil and grease, and change oil.
3. Apply grease sufficiently to the piston rods of the
hydraulic cylinders where they are exposed.
4. Remove and store the battery separately.
5. Check the antifreeze in the coolant.
Add the antifreeze for adequate protection when
temperatures down to the following values.
Temperature -25 ℃
Measures during storing
1.
Recharge the battery regularly.
Restarting after storing
1. Remove the grease applied to the piston rods of the
hydraulic cylinders.
2. Check all oil levels, the sediment trap of the fuel
system, the tire pressure and the functioning of the
disc brake, and the parking brake.
3. Run the engine with no load and operate all the
functions of the hydraulic system.
CAUTION WHEN WASHING THE
MACHINE
• Stop
the engine before washing the machine. If you
wash the machine while running the engine,
splashing water will get into the air cleaner through
its intake and cause engine trouble.
• W
ash carefully and do not splash the water over
the air cleaner.
COMPLETION OF OPERATION AND STORING
STORING THE MACHINE
To Next Page
Loading...
Need help?
General
