KYMCO Bet & Win 250 User Manual

3. INSPECTION/ADJUSTMENT
3-10
Bet & Win 2 50
Coolant capacity : 1165cc
Radiator capacity : 825cc
Reserve tank capacity : 340cc
Start the engine and check if there are no
bubbles in the coolant and the coolant level is
stable. Reinstall the radiator cap.
If there are bubbles in the coolant, bleed air
from the system.
Fill the reserve tank with the recommended
coolant up to the upper line.
BRAKE SYSTEM
BRAKE LEVER
Measure the front and rear brake lever free
plays.
BRAKE FLUID
Turn the steering handlebar upright and check
if the front/rear brake fluid level is at the
upper limit. If the brake fluid is insufficient,
fill to the upper limit.
Specified Brake Fluid: DOT-3
BRAKE DISK/BRAKE PAD
Check the brake disk surface for scratches,
unevenness or abnormal wear.
Check if the brake disk rubout is within the
specified service limit.
Check if the brake pad wear exceeds the wear
indicator line.
Wear Indicator Line
Drain Bolt
Rear Brake Reservoir
Brake Disk
• The brake fluid level will decrease if the
brake pads are worn.
＊
• Keep grease or oil off the brake disk to
avoid brake failure.
＊
Front Brake Reservoir
www.PlanDeGraissage.org

KYMCO Bet & Win 250 Specifications

General

Displacement	249.4 cc
Cooling System	Liquid-cooled
Fuel System	Carburetor
Transmission	CVT
Front Suspension	Telescopic fork
Front Brake	Disc
Rear Brake	Disc
Fuel Capacity	12 liters
Ignition	CDI
Width	770 mm
Height	1, 370 mm
Seat Height	780 mm
Engine Type	4-stroke, single-cylinder