Kyocera TASKalfa 181 User Manual

Copying Functions
4-32 OPERATION GUIDE
Program Function
After registering sets of frequently used functions as a single program, you can simply press the program
number as needed to recall those functions. You can also name the programs for easy identification when
recalling.
Registering Programs
Use the procedure below to register a program.
The following procedure is an example of registering the copying function.
1 Press the Program key while the copy mode is
accessed.
2 Press U or V to select Register program, and
then press the Enter key.
NOTE: If you select a program number already
registered, the currently registered functions can be
replaced with a new set of functions.
3 Press U or V to select the program number to
register (1 to 8), and then press the Enter key.
The program is registered.
NOTE: You can also select the program number using
a numeric key.
Recalling Programs
Use the procedure below to recall a registered program.
1 Press the Program key.
2 Press U or V to select the program number to
recall, and then press the Enter key.
NOTE: You can also select the program number using
a numeric key.
3 Place the originals and press the Start key.
Copying starts with the settings that were
registered.
Register program .
Program:
Program #7
Program #8
Program #3
Register program :
Program #1
Program #2
Program #3
Program:
Program #1
Program #2

Kyocera TASKalfa 181 Specifications

General

Print Technology	Laser
Type	Monochrome
Print Resolution	600 x 600 dpi
Copy Resolution	600 x 600 dpi
Scan Resolution	600 x 600 dpi
Duplex Printing	Manual
Memory	64 MB
Functions	Print, Copy, Scan
Print Speed	18 ppm
Copy Speed	18 cpm
Paper Capacity	250 sheets
Connectivity	USB 2.0
Supported Operating Systems	Linux