Copying Functions
4-8 OPERATION GUIDE
Collate Copying
Since copying in this mode is performed after multiple originals have been scanned and memorized, a required
number of collated copy sets can be produced.
NOTE: If the optional document processor is installed, you can select whether or not to turn on the collate
mode at a default setting. Refer to Collate Copying on page 6-9.
Scan multiple originals and deliver complete sets of
copies as required according to page number.
1 Press the Copy key.
2 Place the originals on the platen.
3 Press the Collate key.
4 Enter the number of copies and press the Start key.
Scanning of the original starts.
If the originals have been set in the optional
document processor, copying starts automatically.
If the original has been set on the platen, a
message prompting replacement of the original is
displayed. In this case, proceed to the next step.
5 Replace the original and press the Start key.
Scanning of the original is performed.
6 After scanning all originals, press the Enter key to
start copying.
To Next Page
Loading...
Need help?
General
