Kyocera TASKalfa 181 User Manual

Copying Functions
OPERATION GUIDE 4-3
4
Adjusting Density
Use this procedure to adjust the density when copying.
NOTE: You can switch to the auto density mode if the overall copies come out too dark or too light. Refer to
Auto Density Adjustment on page 6-7.
If you select Photo as the image quality mode, you cannot select the Auto Density mode.
The procedure for adjusting the density of copies is explained below.
1 Press the Copy key.
2 Place the originals on the platen.
3 Adjust density manually pressing Lighter to
Darker key.
To change density adjustment from Manual to Auto,
press the Auto Density key.
4 Press the Start key to start copying.
Mode Description
Auto Density mode The machine detects the density of the original
and sets the optimum density.
Manual Density mode Adjust the density by pressing the Lighter or
Darker key.

Kyocera TASKalfa 181 Specifications

General

Print Technology	Laser
Type	Monochrome
Print Resolution	600 x 600 dpi
Copy Resolution	600 x 600 dpi
Scan Resolution	600 x 600 dpi
Duplex Printing	Manual
Memory	64 MB
Functions	Print, Copy, Scan
Print Speed	18 ppm
Copy Speed	18 cpm
Paper Capacity	250 sheets
Connectivity	USB 2.0
Supported Operating Systems	Linux