Printing Functions
5-50 OPERATION GUIDE
Stapling Error Detection
You can select whether or not to display Add Staples and Press GO when staples have run out while stapling
is performed.
NOTE: This setting is displayed only if the optional finisher is installed.
1 Display the Others screen. (See How to Display the
Others Screen on page 5-45.)
2 Press U or V to select Finishing Error, and
then press the Enter key.
3 Press U or V to select Staple Setting, and
then press the Enter key.
4 Press U or V to select On or Off, and then press
the Enter key.
5 Press the Reset key.
The message display returns to the printer basic
screen.
Service Status Page Printing
The service status page contains more detailed printer setting information than the normal status page. This
page is mainly used by the service personnel for maintenance. Use the following procedure to print this page as
needed.
1 Display the Others screen. (See How to Display the
Others Screen on page 5-45.)
Setting Processing
On • If you select GO, printing is performed without stapling.
• If you select CANCEL, printing is cancelled.
Off Printing is performed without stapling.
To Next Page
Loading...
Need help?
General
