Part Names
OPERATION GUIDE 1-3
1
24 Lighter key / Darker key
25 Message display
26 Ready indicator (green)
27 Data indicator (green)
28 Attention indicator (red)
29 Logout key
30 Interrupt key and indicator
31 Energy Saver key and indicator
32 Power key and indicator
33 Numeric keys
34 Reset key
35 Stop/Clear key
36 Start key and indicator
37 Main power indicator
Initial mode
Initial mode is the state that the machine enters at the end of warm-up or when the Reset key is pressed.
In the factory default setting, paper of the same size as the original is selected automatically (auto paper
selection mode), the copy magnification ratio is set to 100 %, the number of copies to be made is set to 1 and
the image quality is set to the Text + Photo mode.
NOTE: The settings for the initial mode can be changed using the default setting procedure. For details, refer
to Default Setting Mode on page 6-2.
It is possible to change the cassette selected in the initial mode. For the 18 ppm model, the optional paper
feeder must be installed. For details, refer to Default Cassette on page 6-6.
It is possible to change the image quality mode selected in the initial mode. For details, refer to Original Image
Quality on page 6-3.
It is possible to change the default setting of the exposure to Auto exposure mode. For details, refer to Density
Mode on page 6-3.
Auto Clear Function
Once a designated amount of time has passed after copying stops (between 10 and 270 seconds), the machine
will return to the same settings as those after warm-up. Copies can continually be made using the same settings
(copy mode, number of copies, and exposure mode) if the next batch of copying is started before the auto clear
function is activated.
NOTE: For setting the time that passes before the auto clear function is activated, refer to Chapter 6 Auto
Clear Time.
To Next Page
Loading...
Need help?
General
