5-39
Operation on the Machine > Sending
WSD Scan/DSM Scan
WSD Scan
WSD Scan saves images of originals scanned on this machine as files on a WSD-compatible computer.
Installing Driver Software (for Windows 7)
1
Click the [Start] button on the Windows, and then click
[Network].
In Windows 8, select the Desktop in the Start screen and click [Libraries], and then
[Network].
2
Install the driver.
Right-click the machine's icon (Kyocera: XXX:XXX) and then click [Install].
During the installation, double-click the icon shown on the task bar to display the "Driver
Software Installation" screen. When "Your devices are ready to use" is displayed on the
[Driver Software Installation] screen, the installation is completed.
To use WSD Scan, confirm that the computer used for WSD scanning and the machine is network-connected, and
WSD Scan
on page 8-45 is set to [On] in the network settings.
For information on operating the computer, refer to the computer's help or the operation guide of your software.
When [Network] does not appear in the Start menu, perform the following procedure.
1 Right-click [Start] and click [Property] in the menu that appears.
2 Select the [[Start] menu] tab in the "Task bar and [Start] menu properties" screen, and
click [Customize].
3 When the "Customize [Start] menu" screen appears, select the "Network" check box
and click [OK].
If the "User Account Control" window appears, click [Continue].
If the "Found New Hardware" window appears, click [Cancel].