WAVERUNNER XI SERIES
Adding Printers and Drivers
Note: If you want to add a printer driver, the driver must first be loaded on the oscilloscope.
1. In the menu bar, touch File, then Print Setup... in the drop-down menu. The Utilities Hardcopy dialog opens.
2. In the dialog area, touch the Printer icon
3. Touch the Add Printer button. An MS Windows® window with which to add a printer will open.
mber of copies.
ult Printer
1. Minimize the instrument application by touching File in the menu bar, then Minimize in the drop-down menu.
en.
ter, then touch File, Set as Default Printer.
n USB memory, internal hard drive or network drives. You
rd drive to floppy disk. You also can give your files custom names and create
ent's hard disk is partitioned into drive C: and drive D:. Drive C: contains the Windows operating
the instrument application software. Drive D: is intended for data files.
ETHERNET CONNECTION
Use the Ethernet connector (item 5 in the rear panel diagram) to connect the instrument to a network.
4. Touch the Properties button to change printer properties such as nu
Changing the Defa
If you want to change the default printer:
2. Touch the Start button in the task bar at the bottom of the scre
3. Select Settings Æ Printers.
4. Touch the printer you want to set as the default prin
Managing Files
Use the instrument's utilities to create waveform files o
can copy files from your ha
directories for them.
Hard Disk Partitions
The instrum
system and
100BASE-T
Connecting to a Network
Communicating over the Network
ment uses Dynamic Host Configuration Protocol (DHCP) as its addressing protocol. Therefore, there is
rk
nter Sharing:
derlying desktop.
2. From the toolbar select Start Æ Control Panel Æ Network Connections Æ Local Area Connection.
The instru
no factory set IP address.
File and Printer Sharing over a Netwo
By default, this feature is disabled. To re-enable network File and Pri
1. Minimize the oscilloscope application to reveal the un
84 WRXi-OM-E Rev C
To Next Page
Loading...
Need help?
General
