To Next Page

To Previous Page

5: Getting started

Using the GR25 Internal Battery and Charger

Charging

•

Battery charging can be enabled in the GR25 Web Interface. Go to Receiver setup / Power management.

Note: When charging the GEB241 battery with the GR25 internal charger, it is technically possible to charge the

GEB241 battery between 0°C to +65°C/ +32°F to +149°F. Please note the internal temperature reading on the GR25

web interface

• When the GR25 is turned on, the battery charging status is indicated in the GR25 Web Interface.

• When the GR25 is powered down, battery charging is indicated via the LEDs. For further information refer to LED

Indicators on the GR25.

Default Chapter3
- Table of Contents3
1 : Introduction14
- How to Use the Online Help: Overview14
- How to Display and Use the Online Help15
- How to Find a Online Help Topic16
- How to Print a Online Help Topic17
- Available Documentation18
2 : Description of the System19
- Description of the System: Overview19
- General Information20
- GNSS Reference Station Components21
- Minimum Setup Components22
- Main Components23
- Unpacking the Instrument24
- Instrument Components: GR/GM1025
- Instrument Components GR2526
- Operation27
- Software: Overview29
- Power Supply31
3 : Installation33
- Installation: Overview33
- Before Installation34
- Installation Options35
4 : User Interface39
- User Interface - Overview39
- LED Indicators on GR/GM1040
- Keyboard GR/GM1042
- USB and SD Card Cover GR/GM1045
- LED Indicators on GR2546
- Keyboard: GR2549
- Display: GR2550
- USB and SD Card Cover: GR2555
- Web Interface: Login56
- Web Interface: User Interface57
  - Menu Bar58
  - Tool Tips64
5 : Getting Started67
- Operation: Overview67
- Network Technology and Protocol Overview68
- Basic Setup Step-By-Step69
- Setup Via Web Interface over Ethernet and DHCP70
- Setup in a Non-DHCP Network71
- GR25 Setup in a Non-DHCP Network Using Screen and Buttons73
- Install USB Drivers74
- Install USB Drivers for Windows XP Operating Systems75
- Install USB Drivers for Windows Vista Operating Systems77
- Install USB Drivers for Windows 7 Operating Systems79
- Setup Via Web Interface over USB81
- Troubleshooting: Installing USB Drivers82
- Setup Via Web Interface over Bluetooth83
- Setup Via Web Interface over WLAN (GR25)84
- Batteries Operating Principles85
- Charging the GR25 Battery86
- Using the GR25 Internal Battery and Charger87
- Working with the Memory Device88
- Insert and Remove an SD Card into the Instrument Step-By-Step89
- Use DHCP to Automatically Assign an IP Address and All Network Parameters to an Instrument90
- Use a Hostname to Access an Instrument with a Static IP Address91
- Access the Web Interface for the First Time and Change the Default User92
- Activate Leica Support Access Step-By-Step93
- Configure Coordinates and Site Name Step-By-Step94
- Configure Tracking Settings Step-By-Step95
- Configure a RINEX Logging Session Step-By-Step96
- Configure a Data Stream Step-By-Step97
6 : Context Sensitive Help99
- Context Sensitive Help: Overview99
- Status: Overview100
- Status: Receiver Information - Receiver101
- Status: Receiver Information - Options103
- Status: Position104
- Status Tracking: General106
- Status Tracking: GPS108
- Status Tracking: GLONASS109
- Status Tracking: GALILEO110
- Status Tracking: SBAS111
- Status Tracking: BEIDOU112
- Status Tracking: QZSS113
- Status: Sky Plot114
- Status: Data Streams - Outgoing115
- Status: Data Streams - Incoming117
- Status: Logging Sessions119
- Status: Ntrip Caster121
- Status: Port Summary122
- Status: Antenna124
- Status: Event Log125
- Status: Network Connections127
- Status: System Resources130
- GNSS Management: Overview132
- GNSS Management: Site Name and Coordinates133
- GNSS Management: Tracking General136
- GNSS Management: Tracking GPS141
- GNSS Management: Tracking GLONASS142
- GNSS Management: Tracking GALILEO143
- GNSS Management:tracking BEIDOU145
- GNSS Management: Tracking QZSS146
- GNSS Management: Data Streams Overview147
- GNSS Management: Outgoing Data Streams148
- Outgoing Data Stream Wizard: Select Data Stream150
- Outgoing Data Stream Wizard: Configure Real Time out Data Stream151
- Outgoing Data Stream Wizard: Configure LB2 Data Stream154
- Outgoing Data Stream Wizard: Configure NMEA Data Stream155
- Outgoing Data Stream Wizard: Configure BINEX Data Stream156
- Outgoing Data Stream Wizard: Connection157
- Outgoing Data Stream Wizard: Configure TCP/IP Server158
- Outgoing Data Stream Wizard: Configure TCP/IP Client159
- Outgoing Data Stream Wizard: Configure Ntrip Server (Source)160
- Outgoing Data Stream Wizard: Configure Serial Port162
- Outgoing Data Stream Wizard: Configure Radio163
- Outgoing Data Stream Wizard: Configure GSM / Modem / CDMA - Dial up164
- Outgoing Data Stream Wizard: Set Streaming Status165
- GNSS Management: Incoming Data Streams166
- Incoming Data Stream Wizard: Select Data Stream168
- Incoming Data Stream Wizard: Configure Meteo169
- Incoming Data Stream Wizard: Configure Tilt171
- Incoming Data Stream Wizard: Configure Real Time in Data Stream173
- Incoming Data Stream Wizard: Connection177
- Incoming Data Stream Wizard: Configure TCP/IP Server178
- Incoming Data Stream Wizard: Configure TCP/IP Client179
- Incoming Data Stream Wizard: Configure Ntrip Client180
- Incoming Data Stream Wizard: Configure Serial Port182
- Incoming Data Stream Wizard: Set Streaming Status183
- GNSS Management: Logging Sessions Overview184
- GNSS Management: Logging Sessions185
- GNSS Management: Smart Clean-Up188
- Logging Session Wizard: Create a New Logging Session / Edit a Logging Session190
- Logging Session Wizard: Session Timing192
- Logging Session Wizard: MDB194
- Logging Session Wizard: RINEX195
- Logging Session Wizard: Compact RINEX (Hatanaka)196
- Logging Session Wizard: Data Handling197
- Logging Session Wizard: Set Logging Status198
- GNSS Management: FTP Push199
- GNSS Management: External USB Drive201
- GNSS Management: New / Edit FTP Location203
- GNSS Management: Antenna Management Overview204
- GNSS Management: Select Antenna205
- GNSS Management: Antenna Management206
- GNSS Management: Create/Edit an Antenna208
- GNSS Management: Calculate the Antenna Height Reading209
- Receiver Setup: PPS and Event in210
- GNSS Management: Wake-Up Sessions211
- GNSS Management: New/Edit Wake-Up Session214
- Receiver Setup: Overview215
- Network Connections: Overview216
- Network Connections: General217
- Network Connections: Ethernet219
- Network Connections: Mobile Internet221
- Network Connections: Bluetooth223
- Network Connections: WLAN224
- Network Connections: New / Edit WLAN Profile226
- Receiver Setup: Residential Gateway229
- Access Management: Overview231
- Access Management: User Management232
- Access Management: Access Settings233
- New User / Edit User235
- GNSS Spider and Remote Access: Overview238
- Remote Access Wizard: Connection240
- Remote Access Wizard: Configure TCP/IP Server241
- Remote Access Wizard: Configure TCP/IP Client242
- Remote Access Wizard: Configure Ntrip Server (Source)243
- Remote Access Wizard: Configure Serial Port244
- Remote Access Wizard: Configure Radio245
- Remote Access Wizard: Configure GSM / Modem / CDMA246
- Remote Access Wizard: Set Port Status247
- Ntrip Caster: Overview248
- Ntrip Caster: Caster Tab249
- Ntrip Caster: Mount Points Tab251
- Create New Mount Point252
- Receiver Setup: Web Server254
- Receiver Setup: Dyndns260
- Receiver Setup: FTP Server263
- Device Management: Overview265
- Device Management: Modem / Phone266
- Device Management: Radio267
- Device Management: New / Edit Modem/Phone Device268
- Device Management: GPRS / Internet Initialization269
- Device Management: GSM / CSD Initialization270
- Receiver Setup: Event Log271
- Receiver Setup: Power Management273
- Receiver Setup: SNMP277
- Receiver Setup: Tools - Overview280
- Receiver Setup: Tools281
- Receiver Setup: Firmware Management283
- Receiver Setup: Option Management285
- Receiver Setup: Language Management287
- Receiver Setup: Receiver Settings Backup288
- File Upload289
- Support: Overview290
- Support: Properties291
- Support: Support Tool292
- Support: Leica Active Assist293
7 : GR/GM Series Software295
- Software: Overview295
- Is My Firmware up to Date297
- Firmware Upgrade Step-By-Step298
- Firmware Upgrade Using Leica GNSS Spider302
- Loading a Language File303
8 : GNSS Spider / Remote Access305
- GNSS Spider / Remote Access: Overview305
- GNNS Spider / Remote Access306
- GNSS Spider <-> GR/GM Configuration308
- GNSS Spider Logging Session309
- GNSS Spider Data Streams310
9 : How to311
- How To: Overview311
- How to Set up a Mobile Internet Connection312
- How to Use Dyndns Service on the Receiver314
- How to Backup and Restore Receiver Settings315
- How to Configure Ntrip317
- How to Configure FTP Push of Logged Data320
- How to Reset the Receivers Settings322
- How to Use Bluetooth on the GR25324
- How to Use WLAN on the GR25326
- How To: Backup Communication328
- How to Use Residential Gateway330
10 Support Resources333
11 : External Devices335
- External Devices: Overview335
- Leica Surveying Controllers CS10/CS15337
- Working with Radio, Modem and GSM Devices: Overview338
- Serial Devices339
- Slot-In Devices342
- Configure a Meteo Device Step-By-Step345
- Configure a Tilt Device Step-By-Step346
- External Oscillator347
12 : Default Settings349
- Default Settings: Overview349
- Format Receiver Settings Via Web Interface Step-By-Step350
- Format Receiver Settings Via Instrument Buttons Step-By-Step351
- Restore Default Values352
13 Technical Data353
- Tracking Characteristics353
- Accuracy355
- Technical Data356
- Antenna Technical Data361
14 Legal Information365
Appendix A: Ports & Pin Assignments367
- Ports & Pin Assignments: GR/GM10367
- Ports & Pin Assignments: GR25369
Appendix B: NMEA Messages371
- B1: NMEA Messages - Overview371
- B2: Used Symbols for Describing the NMEA Formats372
- B3: GGA - Global Positioning System Fix Data375
- B4: GGK - Real Time Position with DOP376
- B5: GGK-PT - Real Time Position with DOP, Trimble Proprietary377
- B6: GGQ - Real Time Position with CQ378
- B7: GLL - Geographical Position Latitude/Longitude379
- B8: GNS - GNSS Fix Data380
- B9: GSA - GNSS DOP and Active Satellites381
- B10: GSV - GNSS Satellites in View382
- B11: RMC - Recommended Minimum Specific GNSS Data383
- B12: VTG - Course over Ground and Ground Speed384
- B13: ZDA - Time and Date385
Appendix C: RTCM Messages387
- RTCM Message Types387
Appendix D: RINEX389
- RINEX MET Observation Types389
- RINEX Auxiliary File Definition390
- Appendix: E Web Interface: Directory Structure of the Menu Bar393
Appendix E: Web Interface: Directory Structure of the Menu Bar393
Appendix F: Directory Structure of the Memory Device397
- Directory Structure of the Memory Device397
Appendix G: GR/GM Default Settings399
- Appendix F: Default Settings399
Appendix H: Event Log Messages409
- Event Log Messages409
Appendix I: Glossary411
- Glossary: Overview411
- Almanac413
- Antenna Reference Point (ARP)414
- Anti Spoofing (AS)415
- Binex416
- Cdma417
- Cmr/Crm418
- Cut-Off Angle419
- Cycle Slip420
- Dilution of Precision (DOP)421
- Dynamic Host Configuration Protocol (DHCP)422
- Dyndns423
- Ephemeris424
- Exfat / FAT64425
- Ftp426
- Glonass427
- GPS (System) Time428
- Gsm429
- Hatanaka430
- Http431
- Https432
- Lb2433
- Leica 4G434
- Leica Format435
- Lli436
- Mdb437
- Nmea-0183438
- Ntrip439
- Real Time Message Satellite Signal Support441
- Rinex442
- Rtcm Sc-104443
- Selective Availability (SA)444
- Signal-To-Noise Ratio (SNR)445
- Smtp446
- Ssid447
- Time Zone448
- UTC (Coordinated Universal Time)449
- Wgs84451
- Wide Area Augmentation System (WAAS)452
- World Geodetic System 1984 (WGS 84)453
- Index455
  - Firmware Upgrade Using Leica GNSS Spider 294456
  - Met3A 161457
  - Site Name 125458

Brand	Leica
Model	GR10
Category	Receiver
Language	English

Leica GR10 User Manual

Table of Contents

Other manuals for Leica GR10

Questions and Answers:

Leica GR10 Specifications

Related product manuals