6: Context sensitive help
231
Access Management: Access settings
Background Information
The access settings allow the Administrator to
• configure the user access to the web interface
• Access a link to the FTP server access restrictions page
Setting Descriptions
The table below describes the settings that can be configured on the Access settings tab.
Access to Web interface is
Set the security level for web interface access. If the access settings are changed
you will be automatically logged out.
• Unrestricted
All settings and information in the web interface can been viewed and
changed without login. This setting is very insecure and therefore only
recommended
for example on internal networks where access without official
authorization is not possible.
• Partially restricted
The user can see the Status information when opening the web interface in
a browser window. Display of the Configuration settings requires a user
name and password to log in. The settings available after login depend on
the user status of the logged in user.
• Fully restricted
Requires a user name and password to show any information on the web
interface. When the receiver URL is entered in a browser window, the login
details have to be entered. The settings available after login depend on the
user status of the logged in user.
The Web interface access description below provides a summary of which pages
will be available for each user depending on the access level.
Set FTP access restrictions
Press the configure the FTP server access restrictions link. The Receiver setup:
FTP server page will open.
If the access settings are changed, all users will be required to login again.
Web interface access description
The Web interface access description provides a summary of which menus will be available for each user depending on
• whether the selected Access to Web interface is: Unrestricted, Partially restricted or Fully restricted, and
To Next Page
Loading...
Need help?
General
