Operational Manual (Online Help)
94
Configure a RINEX logging session step-by-step
This section explains how to configure a continuous RINEX logging session.
Access the web interface.
Go to page GNSS management / Logging sessions.
Use the button Create a new logging session .
The logging session wizard will start.
On the first page of the wizard enter a session name and choose RINEX 2.11 or RINEX 3.01in the list box
Data type. Select a session priority and choose continuous in list box Session type. Then use the
On the next page choose a logging rate, the length of the logged file, the dynamics of the session and
activate the check box if Doppler observations should be logged. Then use the Continue button.
On the following page you can choose if the logged files should be zipped, you can select a directory
naming convention, choose an FTP location where the files should be sent to and set an interval after which
the files should be deleted from the memory device.
Note that you have to set up an FTP location on page GNSS management / FTP location before you can
choose it in the respective list box.T hen use the Continue button.
On the last page of the wizard you can activate the logging session. In this case the logging will immediately
start. If you do not activate the check box Activate session the session will be saved with all its settings but
it will not be started. Press the Save changes button to save all settings.
To Next Page
Need help?
General
