Firmware ≤ 11.00 - DMS 8.0 EN - 10/2011 L 117
8400 StateLine C | Reference manual
Motor control (MCTRL)
Selecting the control mode
5.2 Selecting the control mode
The 8400 StateLine controller supports various modes for motor control (open loop or
closed loop).
V/f characteristic control (VFCplus) with linear characteristic for asynchronous motors
is preset.
The control mode can be selected in the »Engineer« on the Application parameter tab
via the Motor control (C00006
) list field:
A click on the Motor control... button leads you to the parameterisation dialog of the
selected motor control. (The button is labelled according to the selected motor control.)
Tip!
In order to make the selection of the motor control easier, we provide a selection
help with recommendations and alternatives for standard applications in the
subchapter entitled "Selection help
". ( 121)
The following section briefly describe the control modes. A reference to more details can
be found at the end of each section.
To Next Page
Loading...
Need help?
General
