Firmware ≤ 11.00 - DMS 8.0 EN - 10/2011 L 41
8400 StateLine C | Reference manual
Introduction: Parameterising the controller
Device access protection
2.4 Device access protection
This function extension is available from version 06.00.00!
Various tasks can be carried out via the functions of the device access protection:
Password protection
– Only authorised persons (who know the password) are permitted to read/change all
parameters of the controller.
– Unauthorised persons (who do not know the password) are only granted access to
the max. 32 parameters of the user menu.
Device personalisation
– Only controllers and memory modules which are personalised with a specific binding
ID can be used for the system.
Note!
If password protection/device personalisation is used:
• Let the end customer know that Lenze can only provide limited service in case
of devices with access protection.
• Lenze cannot modify e.g. a replacement device via special access to make it
work with a personalised memory module.
• The keypad does not support the alpha-numeric entry of a password, thus the
keypad cannot be used for entry.
To Next Page
Need help?
General
