Lenze 8400 StateLine C User Manual

Firmware ≤ 11.00 - DMS 8.0 EN - 10/2011 L 433
8400 StateLine C | Reference manual
System bus "CAN on board"
LED status displays for the system bus
Example: Setting of the node address 23
10.3 LED status displays for the system bus
DIP switch 64 32 16 8 4 2 1
Switch position OFF OFF ON OFF ON ON ON
Value 0 0
16 0 4 2 1
Node address = Sum of the values = 16 + 4 + 2 + 1 = 23
 CAN-RUN:
Signals the CANopen state
 CAN-ERROR:
Signals a CANopen error
Frequency of the display CAN signalling and meaning
Permanently red CAN-Run: -, CAN-Error: Bus Off
Flashes Automatic detection of baud rate is active
Green is blinking every 0.2 s CAN-Run: Pre-Operational, CAN-Error: -
Green is blinking every 0.2 s
Red is blinking once, 1 s off
CAN-Run: Pre-Operational, CAN-Error: Warning Limit reached
Green is blinking every 0.2 s
Red is blinking twice, 1 s off
CAN-Run: Pre-Operational, CAN-Error: Node Guard Event
Permanently green CAN-Run: Operational, CAN-Error: -
Permanently green
Red is blinking once, 1 s off
CAN-Run: Operational, Fault: Warning Limit reached
Permanently green
Red is blinking twice, 1 s off
CAN-Run: Operational, CAN-Error: Node Guard Event
Permanently green
Red is blinking 3 times, 1 s off
CAN-Run: Operational, CAN-Error: Sync Message Error
Green is blinking every second CAN-Run: Stopped, CAN-Error: -
Green is blinking every second
Red is blinking once, 1 s off
CAN-Run: Stopped, CAN-Error: Warning Limit reached
Green is blinking every second
Red is blinking twice, 1 s off
CAN-Run: Stopped, CAN-Error: Node Guard Event
CAN-RUN
CAN-ERROR
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com

Lenze 8400 StateLine C Specifications

General

Brand	Lenze
Model	8400 StateLine C
Category	Inverter Drive
Language	English