8400 StateLine C | Reference manual
Diagnostics & error management
Drive diagnostics via keypad/bus system
388 L Firmware ≤ 11.00 - DMS 8.0 EN - 10/2011
Identification data
The parameters listed in the following table belong to the Identification Controller
category of the »Engineer« parameter list and the keypad and serve to display the
identification data of the controller:
C00177/1 Switching cycles mains switching
C00177/2 Switching cycles output relay
C00177/3 Stress counter - short circuit
C00177/4 Stress counter - earth fault
C00177/5 Stress meter clamp
C00178 Time the controller was enabled (elapsed-hour meter)
C00179 Power-up time (power-on time meter)
C00180/1 Running time - control card
C00180/2 Running time - heatsink fan
C00180/3 Running time - internal fan
Parameter Display
C00099 Firmware version (as a string)
C00100 Firmware version (divided into subitems)
C00200 Firmware product type
C00201/1...6 Firmware of the control card and the power section
C00203/1...9 Product type code of the individual device components
C00204/1...9 Serial numbers of the individual device components
Parameter Display
To Next Page
Loading...
Need help?
General
