332 Matrix SPARSH VP110 User Guide
<item id_name="remotedirectory" display_name="Remote Phone Book" priority="3" enable="0" />
</root_favorite_set>
Super Search Template
Search source list in dialing allows the IP phone to search for entries from the desired lists based on the entered
string when in the pre-dialing screen, and then the user can select the desired entry to dial out quickly. The lists
may contain Local Directory, History and Remote Phone Book. You can configure the search source list in dialing
using the supplied super search template (super_search.xml). After setup, place the super search template to the
provisioning server and specify the access URL in the configuration files.
When editing a super search template, learn the following:
• Do not rename the super search template.
• <root_super_search> indicates the start of a template and </root_super_search> indicates the end of a
template.
• The default display names of the directory lists are Local Directory, History and Remote Phone Book.
• When specifying the priority of search results, the valid values are 1, 2, 3. 1 is the highest priority, 3 is the
lowest.
• When enabling or disabling the desired directory list, the valid values are 0 and 1. 0 stands for Disabled, 1
stands for Enabled.
Procedure
Use the following procedures to customize a super search template.
Customizing a super search template:
• Open the template file using an ASCII editor.
• For each directory list that you want to configure, edit the corresponding string in the file. For example,
configure the local directory list, edit the following strings:
<item id_name="local_directory_search" display_name="Local Directory" priority="1" enable="1" />
Where:
id_name=""specifies the directory list (“local_directory_search” for the local directory list). Do not edit this
field.
display_name="" specifies the display name of the directory list. We do not recommend editing this field.
priority="" specifies the priority of search results.
enable="" enables or disables the directory list.
• Specify the values within double quotes.
• Place this file to the provisioning server.
To Next Page
Loading...
Need help?
General
