Technical Information
111
PW 6xx7
Service mode (service level)
3 Service settings
1 Basic settings
6 Payment system
3 Time
4 Serial
5 Electronic purse
Table 100-80: Payment System Options
Make a selection with the multifunction selector switch and confirm with the
OK button. The Back button can be pressed to go back one menu level.
Service mode (service level)
3 Service settings
1 Basic settings
6 Payment system
1 Payment system operation Display Explanation
1
“Payment system: None”,
Back symbol
Factory setting: None.
2
“Payment system:
Program”, Back symbol
The customer pays for a
complete drying program.
The coin/bill dispenser
sends a “start” signal to
the control. This locks the
drying program after 3
minutes and sends a 230V
signal via the 7-pin
interface when the
program is finished.
3
“Payment system: Time”,
Back symbol
The customer pays for a
specific interval of time.
The coin/bill dispenser
sends a duration signal to
the control. This locks the
drying program after 3
minutes. The drying
program will run as long
as the duration signal
exists. When the signal
expires, the program will
stop and can be ended, or
continued through
additional payment.
4
“Payment system: Serial”,
Back symbol
The customer pays via an
external coin/bill dispenser
that controls the machine
via the serial interface in
the communications slot.
The payment-system relay
contact is not used by the
control. All control data is
sent via serial interface.
5
“Payment system:
Electronic purse”, Back
symbol
The customer pays with a
credit card and the IK6
interface card controls the
machine.
Table 100-81: Payment System Options
After selecting a value with the multifunction selector switch, confirm it with
the OK button. The control automatically goes back one level.
Save service messages by pressing and releasing the Save button.
Pressing the Back button quits without saving and goes back one menu
level.
To Next Page
Loading...
Need help?
General
