Technical Information
83
PW 6xx7
4.3 Step Drain Level 1
Initial requirements:
A wash program must not be in operation.
The machine must not be in the service mode.
Accessing:
1. Switch on the machine.
2. Wait until the “Welcome” start screen is displayed.
3. Press the language selection button (under the flag symbol) to access the
main menu.
4. Select Operating level and confirm with the OK button.
5. Enter the password and confirm with the OK button.
6. Select Programming and confirm with the OK button.
7. Select the Set up again or Change submenu and confirm with the OK button.
8. Carry out program header programming.
9. Select a program area and confirm with the OK button.
10. Select a program block and confirm with the OK button.
11. Select program block parameters and confirm with the OK button.
12. Select block parameter 29 for drain level 1 and its current program
settings and confirm with the OK button.
Acknowledgement indicator:
The top line of the display shows “Block programmingBlock parameter”.
The second line shows “29. Drain level 1” and the current program setting.
Options:
This step can be described simply as “drain with or without spin.”
To Next Page
Loading...
Need help?
General
