Technical Information
46
PW 6xx7
3 Fault Repair
3.1 Fault Code Summary
See fault code table.
Note:
Fault numbers may refer to specific faults but can also give information
regarding the machine state. They may also give instructions to the operator
or service technician. Actual saved faults are indicated as such. The fault
numbers given in the table below refer to the fault numbers indicated with
the MDU software (Miele Diagnostic Utility). The entry in the column
“Indication in EW 235 display” refers to the machine control display, not the
indication saved in the fault memory or machine history.
MDU fault # Possible cause Notes Indication in EW 235
display
Fault/Information
F4001 Water in suds
container
Door cannot be opened
because water level ≥ 30 mm
wc in suds container, e.g., after
program interruption or after a
program without drainage cycle.
Information
F4002 Drum rotation, door
cannot be opened
Door cannot be opened
because drum is not stationary.
Information
F4003 Door can be opened Door can be opened. Information
F4004 Door is open Door is open. Information
F4005 Door is closed Door is closed. Information
F4006 Control has limited
water level
Control has intervened in last
program sequence and limited
water level.
Information
F4007 Control has raised
water level
Control has intervened in last
program sequence and raised
water level to protect heating.
Information
F4008 Credit has run out With payment system operation,
credit has expired during wash
cycle.
Fault
F4009 Payment insufficient
for a program
With payment system operation,
credit available at start of
program is insufficient.
Fault
F4010 Maximum program
duration has been
exceeded. Overriding
time control has been
exceeded.
e.g., dryer with residual
moisture programs or washing
machine with Thermostop
programs.
Information
F4011 Frequency converter
fault
Fault
F4012 Frequency converter
excess current fault
Frequency converter excess
current sensor has activated.
Fault
F4013 Frequency converter
intermediate circuit
voltage too low
Frequency converter
intermediate circuit voltage is
too low and power at drive
motor drops.
Fault
F4014 Frequency converter
intermediate circuit
voltage too high
Frequency converter
intermediate circuit voltage is
too high. Input voltage may be
too high.
Fault
F4015 Frequency converter
slip too high
Impermissible slip. Fault
F4016 Impermissible
imbalance at
frequency converter
Fault
To Next Page
Loading...
Need help?
General
