POWER TRAIN
-
Manual Transaxle
2-21
First, second and reverse gears are machined on
shaft gears. The speed gears all have clutch teeth
L
the shaft. Third, fourth and fifth speed gears ride
and cones, which are used to equalize shaft speeds
on caged needle bearings that rotate on the shaft
during shifts. The clutch teeth engage with the syn-
journals. All of the forward gears are helical-type
chronizer sleeves and the cones engage with the
gears, and are in constant mesh with the output
stop rings during a shift.
i
1.
Input shaft
12. Thrust washer
(2-piece)
2. Third gear bearing
13. Fifth gear bearing
3. Third speed gear
14. Fifth speed gear
4. Third stop ring
15. Fifth stop ring
5.
3-4 synchronizer
16. 5-R synchronizer
6.
3-4 synchronizer
snap ring
17. 5-R synchronizer snap ring
7. Fourth stop ring
18. Reverse stop ring
8. Fourth gear bearing
19. Reverse brake bearing race
9. Fourth speed gear
20. Reverse brake bearing
10.
Retaining ring
21. Reverse brake friction cone
11.
Anti-spin pin
22. Thrust washer
0475-040
To Next Page
Loading...
Need help?
General
