2-32
POWER TRAIN
-
Manual Transaxle
Selector
housing
0475-030
(hT=fl
cnlnrtnr
4hift
,I
,,!/,I
I
II
Select&
shaft1
‘5-032
e
t---FF-a
“‘!!I’
fL%;~
;;;
54
t--1.
4
A
l-2,
IWK
0475-033
1 st speed
l-2 shift
fork
2nd speed
0475-034
SHIFT SELECTOR ASSEMBLY
The shift selector assembly moves the appropriate shift fork
based on the drivers selection. The assembly consists of the
selector, shaft, housing, and pin.
The selector housing blocks the other shift forks and prevents
a shift into two gears at the same time. The selector pivots
in an arc to select the different shift forks.
A shift from fifth-to-reverse is blocked by a 5-R guide (guides
from 5th to 4th). The shift assembly has a pin sticking out
of one side that engages the guide as it comes out of fifth
gear. The guide pushes the pin and shift assembly away from
reverse gear.
SHIFT RAILS AND FORKS
The
F5MCl
uses three rail and fork assemblies. All of the
shift forks have dual functions in that they control shifts into
two different gears.
When the 1-2 shift fork moves to the front of the transaxle,
first gear is obtained. When it moves to the rear of the transaxle,
second gear is obtained.
To Next Page
Loading...
Need help?
General
